Book a new repair
0800 030 6040Existing Repairs
0191 387 0118Help & Advice
Help & Advice: Smeg Dishwasher Error Codes
Smeg Dishwasher Error Codes
If you are experiencing problems with your Smeg dishwasher, take a look at our extensive error code guide below to help you find out what the problem is. If you need help repairing your fixing your dishwasher. For a professional service, call Pacifica with free callouts for Smeg repairs nationwide and fast reliable service.
Smeg dishwashers usually come with 3 different types of displays:
- Fully integrated dishwashers with displays
- LED display dishwashers
- 3 button with LCD display
Each of these types of Smeg dishwashers have a different type of error code which are listed and explained below in order.
Fully integrated Smeg dishwashers with display
Error Code
Fault Description
E2
Overfill detected
E3
Not heating
E4
Thermistor disconnected or o/c
E5
No water fill
E6
Heating detected with no water present
E7
Not draining
E8
Read error, rest and try again
E9
Pause in test programme, not a fault code
LED Display Smeg Dishwashers
Error Code
Fault Description
E1 1st flashing, 5th lit
Flood protection system activated
E2 2nd flashing, 5th lit
Safety pressure switch activated
E3 1st, 2nd flashing, 5th lit
No heat in the time allowed
E4 3rd flashing, 5th lit
Temperature sensor fault
E5 1st, 3rd flashing, 5th lit
No fill
E6 2nd, 3rd flashing, 5th lit
No drain in the time allowed
E7 1st, 2nd, 3rd flashing
Flowmeter detected when not fitted reset required
E9
Flood protection system activated
3 Button with LCD Display Smeg Dishwashers
Error Code
Fault Description
E1
Overfill detected
This will abort the current program
E2
Water level.
This will abort the current program
E3
Not heating.
This will abort the current program
E4
Temperature probe or thermostat failure
E5
No fill.
This will not cause the machine to halt. To reset, open and close the door or press start
E7
No drain.
This will not cause the machine to halt. To reset, open and close the door or press start
E9
Water level.
This will abort the current program